![]() In its current state, the camera won't start Canon firmware, but will start ML (because "MAIN_FIRMWARE flag is DISABLED" is printed from. OP should either install Canon firmware (which should fix the boot flags in ROM), or prepare a ML card with EOSCard Halfway through it asked me to reboot, I did.Ĭan you elaborate a bit more? What does it mean "halfway through"? Progress bar jumped from around 50 to 100%? Which downgrade method have you used? BIG shoutout to the ML team, especially at_ML, Kitor and A1ex, for helping me get here and hopefully someone will find this post if they are stuck with the same problem as me.Īs we just had a bit of discussion on ML development discord about your issue: You can now either try the installation of ML again or roll with it and use the standard Canon firmware. Pull out battery, Turn OFF/ON switch to OFFĬamera is asking if you want to update from 2.0.3 to 2.0.3Ĭamera will now be restored to normal functionality Run EOScard.exe (make sure the right card is selected, click ML icon once, press save, check bottom to see if it says "write succesful") ![]() Rename copied 7D000203.FIR to ML-SETUP.FIR With the help of the ML team we got the camera working again! So in basic what I did was the following step by step.Ĭopy contents of ZIP file (magiclantern-Nightly.2018Jul03.7D203 <- might be different for other models) ![]() Scouwered half the internet on "remove battery, remove card, remove internal battery, diagnostics file, pray to the seven gods of the sea and preform a ritual".Īll seems to lead back to "update file cannot be found" and now I'm stuck with a dead camera :( All I wanted was to use this camera for streaming without it cutting out on me or having to use the terrible EOS Webcam Utility software. ![]() I've tried getting the original firmware back on, tried a fresh install of the ML on the sd card but nothing seems to work. Halfway through it asked me to reboot, I did. Uploaded the whole content of the ML zip folder.Ĭam said "update file cannot be found" a couple of times. Downgraded from 2.0.6 to 2.0.3 formatted 2gb card. Can anyone help me? :) I've tried a lot of things already.
0 Comments
Leave a Reply. |